GW Instek GPP-2323 - Page 105

REMOTE CONTROL
105
Manual IP
A. Press the System button to enter the system
interface followed by pressing the F1 (Interface)
button to configure port parameter.
B. Press the F4 (LAN) button to configure
internet port parameter.
C. Press the F2 (Config) button to configure
relevant parameter.
D. Press the F3 (Manual) button to manually
configure.
E. press the F1 (IP Addr) button to manually
input IP address. The set content will be
activated to become red color. Input required
data and confirm by pressing the F1 (Done)
button. Press the F5 (Clear) button to clear and
input again if error occurs.
F. return to the Manual configuration menu
and repeat manually configuring NetMask.
Press the F2 (NetMask) button to manually
input data. The set content will be activated to
become red color. Input required data and
confirm by pressing the F1 (Done) button. Press
the F5 (Clear) button to clear and input again if
error occurs.
G. F. return to the Manual configuration menu
and repeat manually configuring GateWay.
Press the F3 (GateWay) button to manually
input data. The set content will be activated to
become red color. Input required data and
confirm by pressing the F1 (Done) button. Press
the F5 (Clear) button to clear and input again if
error occurs.