GW Instek PSH-1070AGP - Miscellaneous Commands; Status Commands

Remote Operation
59
Status commands
*cls Clears all event status registers (Output Queue,
Operation Event Status, Questionable Event
Status, Standard Event Status)
*ese? Returns the ESER (Event Status Enable
Register) contents.
Example: 130→means ESER=10000010
*ese <0~255> Sets the ESER contents.
Example: *ese 65→sets ESER to 01000001
*esr? Returns and clears the SESR (Standard Event
Status Register) contents.
Example: 198→means SESR=11000110
*sre? Returns the SRER (Service Request Enable
Register) contents.
Example: 3→means SRER=00000011
*sre <0~255> Sets the SRER contents.
Example: *SRE 7→SRER=00000111
*stb? Returns the SBR (Status Byte Register) contents.
Example: 81→means SBR=01010001
:stat:oper:cond? Returns the Operation register contents.
:stat:oper:enab? Returns the mask conditions of the event
register. Range: 0~32767
Example: 32767 means all 15bits are set to 1.
:stat:oper:enab
<0~32767>
Returns the mask conditions of the event
register. Range: 0~32767
Example: 32767 sets all 15bits to 1.
:stat:oper:even? Returns the operation register contents.
Example: 32767 means all 15bits are set to 1.
:stat:pres Sets the operation register and questionable
enable register to zero.
:stat:ques:enab
?
Returns the mask conditions of the event
register. Range: 0~32767
Example: 32767 means all 15bits are set to 1.
:stat:ques:enab
<0~32767>
Returns the mask conditions of the event
register. Range: 0~32767
Example: 32767 sets all 15bits to 1.
:stat:oper:even? Returns the questionable register contents.
Example: 32767 means all 15bits are set to 1.
PSH User Manual
60
Miscellaneous commands
*idn? Returns the power supply ID as Manufacturer,
Model No, Serial No, Firmware version.
Example: GW.Inc,PSH-2018A,12345678,FW1.00
*opc? “1” is placed in the output queue when all the
pending operations are completed.
*opc Sets the operation complete bit (bit0) in SERS
(Standard Event Status Register) when all the
pending operations are completed.
*rcl <1~99> Recalls the panel setup from internal memory.
Example: *RCL 1→recalls setup from memory1
*rst Recalls the default panel setup (reset the device).
*sav <1~99> Saves the panel setup to internal memory.
Example: *SAV 1→saves setup to memory1
*tst? Run the self-test for RAM and ROM and returns
0 (successful) or -300 (unsuccessful).
*wai Prevents execution of further commands until all
the pending operations are completed.
:syst:err? Returns the error number followed by the error
message from the queue.
Example: 0, “No error”
:syst:vers? Returns the SCPI version.
Example: 1994.0