GW Instek PSU 300-5 - Page 56

PSU Series Programming Manual
56
Legacy Multi-
Drop mode
When using SCPI commands or TDK GENESYS
legacy commands, each unit can be individually
controlled using the unique address identifiers.
For this function check, we will assume that the
master unit is assigned to address 8, while a slave
is assigned address 11.
Run this query command via the terminal
application after the instruments have been
configured for multi-unit control with Legacy
Multi-Drop mode. See page 47.
SCPI commands
Command or response
Status
INST:SEL 8
Typing
*IDN?
Typing
GW-INSTEK,PSU40-38,,T0.01.12345678
Return
Selects the unit with address 8 and
returns its identity string.
Note
INST:SEL 11
Typing
*IDN?
Typing
GW-INSTEK,PSU6-200,,T0.01.12345678
Return
Selects the unit with address 11 and
returns its identity string.
Note
TDK GENESYS
legacy commands
(Because the terminal character used by the TDK
GENESYS legacy command is CR instead of LF,
the terminal characters are specifically listed
below)
Command or response
Status
ADR 8\r
Typing
OK\r
Return
IDN? \r
Typing
GW-INSTEK,PSU40-38,,T0.01.12345678\r
Return