H3C UniServer R4300 G6 - Page 409

178
Physical 0,14 : Ready (SATA, 512 Bytes, 457862MB, ATA , INTEL SSDSC2KB480G8 ,
Solid State Drive) 500E004AAAAAAA06, [Enclosure 1, Slot 6(Connector 0:CN0)]
Physical 0,15 : Ready (SATA, 512 Bytes, 457862MB, ATA , INTEL SSDSC2KB480G8 ,
Solid State Drive) 500E004AAAAAAA07, [Enclosure 1, Slot 7(Connector 0:CN0)]
Physical 2,0 : Ready (SES2, Not Applicable, Not Applicable, MSCC, SXP 36x12G,
Enclosure Services Device) 500E004AAAAAAA7F, [Connector 0:CN0, Enclosure 1]
Physical 2,1 : Ready (SES2, Not Applicable, Not Applicable, UN , Virtual
SGPIO, Enclosure Services Device) 598F181BA1DBB008, [Not Applicable]
Command completed successfully.
View physical drive, array, LD, and adapter information
Perform this task to view basic information about a storage controller.
Syntax
Table 8 View storage controller information
Command
Function
arcconf getconfig
controller_id
AD
View adapter information.
arcconf getconfig
controller_id
LD
View information about all the LDs.
arcconf getconfig
controller_id
LD
LD_id
View information about the specified LD.
arcconf getconfig
controller_id
PD
View information about all physical drives.
arcconf getconfig
controller_id
PD
channel_id
slot_id
View information about the specified physical drive.
arcconf getconfig
controller_id
AR
View information about all arrays.
arcconf getconfig
controller_id
AR
AR_id
View information about the specified array.
Parameters
controller_id: Specifies the ID of the storage controller.
LD_id: Specifies the ID of a LD.
channel_id: Specifies the channel ID of a drive.
slot_id: Specifies the device ID of a drive.
AR_id: Specifies the ID of an array.
Examples
# View information about all arrays.
[root@localhost ~]# arcconf getconfig 1 ar
Controllers found: 1