H3C UniServer R4300 G6

7
Figure 9 Storage controller configuration screen
2. Perform tasks based on the following guidelines:
 If the screen does not display any logical drives for selection, no logical drive is available or
no logical drive can be rebuilt.
 If the screen displays logical drives for selection, set the target logical drive state to
Enabled, select Goto PD Select, and press Enter.
3. Perform tasks based on the following guidelines:
 If the screen does not display any physical drives, no physical drive is available.
 If the screen displays physical drives for selection, select a target physical drive and press
Enter.
Figure 10 Selecting a physical drive
Viewing physical drive information
1. Access the storage controller configuration screen, select Physical Device Information, and
press Enter.