H3C UniServer R4300 G6 - Page 419

188
Pending VDM Notification : Not Applicable
--------------------------------------------------------
Connector information
--------------------------------------------------------
Connector #0
Connector Name : CN0
Connection Number : 0
Functional Mode : Mixed
Connector Location : Internal
SAS Address : 598F181BA1DBB000
Connector #1
Connector Name : CN1
Connection Number : 1
Functional Mode : Mixed
Connector Location : Internal
SAS Address : 598F181BA1DBB004
Command completed successfully.
Set the drive UID LED
Perform this task to turn on or turn off the UID LEDs for physical drives, logical drives, or all the
drives.
Syntax
Table 9 UID management-related commands
Command Function
arcconf identify
controller_id
device
channel_id slot_id
time
time
Turn on the UID LED for the specified drive for a specific
length of time.
arcconf identify
controller_id
device
channel_id slot_id
Turn on the UID LED for the specified drive. You can press
any key to turn off the LED.
arcconf identify
controller_id
all
time
time
Turn on the UID LEDs for all physical drives for a specific
length of time.
arcconf identify
controller_id
all stop
Turn off the UID LEDs for all physical drives.
arcconf identify
controller_id
logicaldrive
LD_id
time
time
Turn on the UID LED for the specified LD for a specific
length of time.
arcconf identify
controller_id
logicaldrive
LD_id
Turn on the UID LED for the specified LD. You can press
any key to turn off the LED.
arcconf identify
Turn on the UID LED for the specified array for a specific