8
Figure 212 Installing the driver of a FC HBA card for a RedHat device
7. Execute the modinfo qla2xxx command to verify that the driver has been installed
successfully.
Figure 213 Verifying the driver installation
Installing a GPU driver by using a .run file (for RedHat OSs)
This section updates the driver of the M4000 GPU for RedHat 7.3.
Checking GPU information
1. Execute the lspci |grep –i nvidia command to view the bus number of the GPU. In this
example, the bus number is 05:00.0.
Figure 214 Displaying the bus number of the GPU
2. Execute the lspci –vvs bus command to view driver information. The bus argument
represents the bus number of the GPU.
To Next Page
Loading...
