12-24
Examples
# Set the capacity of the token bucket to 50 and the update period to 100 milliseconds.
<Sysname> system-view
[Sysname] ipv6 icmp-error bucket 50 ratelimit 100
ipv6 icmpv6 multicast-echo-reply enable
Syntax
ipv6 icmpv6 multicast-echo-reply enable
undo ipv6 icmpv6 multicast-echo-reply
View
System view
Default Level
2: System level
Parameters
None
Description
Use the ipv6 icmpv6 multicast-echo-reply enable command to enable sending of multicast echo
replies.
Use the undo ipv6 icmpv6 multicast-echo-reply command to disable sending of multicast echo
replies.
By default, the AP is disabled from sending multicast echo replies.
Examples
# Enable sending of multicast echo replies.
<Sysname> system-view
[Sysname] ipv6 icmpv6 multicast-echo-reply enable
ipv6 mtu
Syntax
ipv6 mtu mtu-size
undo ipv6 mtu
View
VLAN interface view
Default Level
2: System level
Parameters
mtu-size: Size of the maximum transmission units (MTUs) of an interface in bytes. The value ranges
from 1280 to 1500.
Description
Use the ipv6 mtu command to set the MTU of IPv6 packets sent over an interface.
To Next Page
Loading...
