12-6 
Field  Description 
OutDiscards 
Sent packets that were discarded due to resource problems rather than 
packet content errors 
 
# Display the brief IPv6 information of all interfaces for which IPv6 addresses can be configured. 
<Sysname> display ipv6 interface 
*down: administratively down 
(s): spoofing 
Interface        Physical  Protocol   IPv6 Address  
Vlan-interface1    down   down   Unassigned 
Vlan-interface2    up   up   2001::1 
Vlan-interface100      up   down   Unassigned 
Table 12-3 display ipv6 interface command output description 
Field  Description 
*down: administratively down 
The interface is down, that is, the interface is closed by using the 
shutdown
 command. 
(s): spoofing 
Spoofing attribute of the interface, that is, the link protocol state of the 
interface is up, but the link does not exist, or the link is established on 
demand, instead of being permanent. 
Interface  Name of the interface 
Physical 
Physical state of the interface: 
z  *down: Indicates that the VLAN interface is administratively down; that 
is, the interface is shut down using the shutdown command. 
z  down: Indicates that the VLAN interface is administratively up but its 
physical state is down; that is, no port in the VLAN is up, which may be 
caused by a connection or link failure. 
z  up: Indicates that the administrative and physical states of the VLAN 
interface are both up. 
Protocol 
Link layer protocol state of the interface: 
z  down: Indicates that the network layer protocol state of the VLAN 
interface is down, generally because no IP address is configured. 
z  up: Indicates that the network layer protocol state of the VLAN 
interface is up. 
IPv6 Address 
IPv6 address of the interface. Only the first of configured IPv6 addresses 
is displayed. (If no address is configured for the interface, “Unassigned” 
will be displayed.) 
 
display ipv6 neighbors 
Syntax 
display ipv6 neighbors { ipv6-address | all | dynamic | interface interface-type interface-number | 
static | vlan vlan-id } [ | { begin | exclude | include } regular-expression ] 
View 
Any view 
Default Level 
1: Monitor level