8-4
interface-type interface-number: Specifies an interface. When the IPv6 address of the DNS server is a
link-local address, the two arguments must be specified.
Description
Use the dns server ipv6 command to specify a DNS server.
Use the undo dns server ipv6 command to remove the specified DNS server.
By default, no DNS server is configured.
You can configure a maximum of six DNS servers, including those with IPv4 addresses.
Examples
# Specify a DNS server at 2002::1.
<Sysname> system-view
[Sysname] dns server ipv6 2002::1
ipv6 host
Syntax
ipv6 host hostname ipv6-address
undo ipv6 host hostname [ ipv6-address ]
View
System view
Default Level
2: System level
Parameters
hostname: Host name, a string of 1 to 20 characters. The character string can contain letters, numbers,
underscores (_), hyphens (-), or dots (.) and must contain at least one letter.
ipv6-address: IPv6 address.
Description
Use the ipv6 host command to configure a mapping between host name and IPv6 address.
Use the undo ipv6 host command to remove a mapping between host name and IPv6 address.
No mappings are created by default.
Each host name can correspond to only one IPv6 address. The IPv6 address you last assign to the host
name will overwrite the previous one if there is any.
Related commands: display ipv6 host.
Examples
# Configure the mapping between a host name and an IPv6 address.
<Sysname> system-view
[Sysname] ipv6 host aaa 2001::1
reset dns ipv6 dynamic-host
Syntax
reset dns ipv6 dynamic-host
To Next Page
Loading...
