11-2
Preferred Server:
Reachable via address : FE80::213:7FFF:FEF6:C818
DUID : 0003000100137ff6c818
DNS servers : 1:2:3::5
1:2:4::7
Domain names : abc.com
Table 11-1 display ipv6 dhcp client command output description
Field Description
in stateless DHCPv6 client
mode
Indicates the client is in the stateless DHCPv6 configuration mode.
State is OPEN
Current state of the DHCPv6 client, which can be:
z INIT: After enabled, the DHCPv6 client enters the INIT state.
z IDLE: After receiving an RA message with the “M” flag set to 0 and “O” flag set
to 1 and enabled with stateless DHCPv6, the DHCPv6 client enters the IDLE
state.
z INFO-REQUESTING: The DHCPv6 client is requesting configuration
information.
z OPEN: The DHCPv6 client successfully obtained configuration parameters
and completed stateless configuration based on the obtained parameters.
Preferred Server Information about the DHCPv6 server selected by the DHCPv6 client
Reachable via address
Reachable address, that is, the link local address of the DHCPv6 server or relay
agent.
DUID DHCP unique identifier (DUID) of the DHCPv6 server
DNS servers DNS server address sent by the DHCPv6 server
Domain names Domain name information sent by the DHCPv6 server
display ipv6 dhcp client statistics
Syntax
display ipv6 dhcp client statistics [ interface interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number: Displays the DHCPv6 client statistics of a specified
interface.
Description
Use the display ipv6 dhcp client statistics command to display DHCPv6 client statistics.
With no parameters specified, DHCPv6 client statistics of all the interfaces will be displayed.
Related commands: reset ipv6 dhcp client statistics.
Examples
# Display DHCPv6 client statistics of VLAN-interface 2.
To Next Page
Loading...
