11-1
z Support of the H3C WA series WLAN access points (APs) for commands may vary by AP model.
For more information, see Feature Matrix.
z The interface types and the number of interfaces vary by AP model.
z The models listed in this document are not applicable to all regions. Please consult your local sales
office for the models applicable to your region.
11 DHCPv6 Configuration Commands
Support for the DHCPv6 configuration commands depends on the AP model.
DHCPv6 Configuration Commands
display ipv6 dhcp client
Syntax
display ipv6 dhcp client [ interface interface-type interface-number ]
View
Any view
Default Level
1: Monitor level
Parameters
interface interface-type interface-number: Displays the DHCPv6 client information of a specified
interface.
Description
Use the display ipv6 dhcp client command to display DHCPv6 client information.
With no parameters specified, the DHCPv6 client information of all the interfaces will be displayed.
Examples
# Display the DHCPv6 client information of VLAN-interface 2.
<Sysname> display ipv6 dhcp client interface vlan-interface 2
Vlan-interface2 is in stateless DHCPv6 client mode
State is OPEN
To Next Page
Loading...
