12-32 
ipv6 neighbor 
Syntax 
ipv6 neighbor ipv6-address mac-address { vlan-id port-type port-number | interface interface-type 
interface-number } 
undo ipv6 neighbor ipv6-address interface-type interface-number 
View 
System view 
Default Level 
2: System level 
Parameters 
ipv6-address: IPv6 address in a static neighbor entry. 
mac-address: Link layer address in a static neighbor entry (48 bits long, in the format of H-H-H). 
vlan-id: VLAN ID in a static neighbor entry, in the range of 1 to 4094. 
port-type port-number: Type and number of  a Layer 2 port in a static neighbor entry. 
interface interface-type interface-number: Type and number of a Layer 3 interface in a static neighbor 
entry. 
Description 
Use the ipv6 neighbor command to configure a static neighbor entry. 
Use the undo ipv6 neighbor command to remove a static neighbor entry. 
Note that you can adopt the IPv6 address and link layer address of the Layer 3 VLAN interface or those 
of the VLAN port to configure a static neighbor entry. 
z  If a static neighbor entry is configured by using the first method, the neighbor entry is in the INCMP 
state. After the AP obtains the corresponding Layer 2 VLAN port information through resolution, the 
neighbor entry will go into the REACH state. 
z  If a static neighbor entry is configured by using the second method, the corresponding VLAN 
interface must exist and the port specified by port-type port-number must belong to the VLAN 
specified by vlan-id. After a static neighbor entry is configured, the AP will relate the VLAN interface 
with the IPv6 address to identify a static neighbor entry uniquely and the entry will be in the REACH 
state. 
You only need to specify the corresponding VLAN interface before removing a static neighbor entry. 
Related commands: display ipv6 neighbors. 
Examples 
# Configure a static neighbor entry for Layer 2 port Ethernet 1/0 of VLAN 100. 
<Sysname> system-view 
[Sysname] ipv6 neighbor 2000::1 fe-e0-89 100 ethernet 1/0 
ipv6 neighbors max-learning-num 
Syntax 
ipv6 neighbors max-learning-num number 
undo ipv6 neighbors max-learning-num