Page 35
Section 3 Technical Specifications
TYPICAL TECHNICAL DATA
Enclosure: Fiberglass Reinforced Polyester
Dimensions (HxWxD): 1250mm x 750mm x 320mm
Enclosure height may increase to 1750mm, depending on system optional
features.
Weight: 90 kg – 120 kg
Enclosure weight may change depending on system optional features.
Power Consumption: 300 W (VA)
Mains Connection: 115V AC, 60Hz or 230V AC, 50Hz (10%)
Other power options are available on request.
Mains Wire Specification: Number of Cores = 3, Current Rating minimum = 10 Amps, CSA (Cross
Sectional Area minimum) = 1.50mm
2
Signal Wire Specification: Number of Cores = 8 (+2 cores per additional signal), Current Rating
minimum = 1 Amp, CSA (Cross Sectional Area minimum) = 0.22mm
2
.
FEATURES IN DETAIL
Display: High Contrast 40 Character x 16 Line Backlit LCD with CFL Backlight
Data Storage: Previous 9999 analysis data on screen in the microcontroller memory and
storage of data archive for the lifetime of the analyzer in the SD/MMC card
Previous 99 fault data on screen in the microcontroller memory and storage
of fault data archive for the lifetime of the analyzer in the SD/MMC card
SD/MMC Card: Flash memory card for data transfer and for software & configuration updates
Operation: Microcontroller with BioTector OS3 Software and Membrane Keyboard
Language Options: English, French, German
Other language options are available on request.
INPUT & OUTPUT SIGNALS
Standard Output: One programmable 4-20mA output signal (typically for TOC)
For systems requiring more than six 4-20mA standard outputs, 4-20mA
Output Multiplex option is implemented to provide 4-20mA data for up to 35
output signals.
Digital Output: Three freely programmable system relays (volt free changeover contact with
a current rating of 1Amp at 30V DC)
One of the system relay is factory set to Fault.
Data Transfer Port: SD/MMC Card and serial RS232 Output for Printer, PC or Data Logger
OPTIONAL FEATURES
Result Output: TIC, TC, VOC, after correlation COD, BOD
Remote Control: Input for remote start / standby
Input for remote stream and range selection
Input for remote manual grab sample analysis
Network Control Unit for remote access over Internet or Intranet connection
using HTTP over TCP/IP protocol
Industrial Interface: Modbus, Profibus, Ethernet
(when any of the Modbus, Profibus or Ethernet option is selected, the digital
output signals are sent through the relevant device with its specific
communication protocol)
Calibration & Cleaning: Valves for Automatic Calibration and Sample Line Cleaning
Multi-stream: Valves for up to 6 streams with up to six 4-20mA signals (TIC & TOC, TC,
VOC systems). The number of available outputs depends on the manual
stream configuration.
Manual stream: Valves for up to 6 manual streams with up to six 4-20mA signals (TIC & TOC,
TC, VOC systems). The number of available outputs depends on the multi-
stream configuration.
To Next Page
Loading...
