17
Section 3 Installation
3.1 Unpacking the instrument
The DR 6000 spectrophotometer package is supplied with the
following items:
• DR 6000 spectrophotometer
• Dust cover
• USB dust cover, fitted as standard
• Power cord for US and EU (when shipped to China power
cord for CN)
• Universal cell adapter
• Operator RFID tag (not available on all models)
• 1 Inch cells, matched pair
• Basic DR 6000 user manual, LINK2SC user manual
• CD-ROM with HACH and HACH-LANGE procedural
instructions and extensive operating instructions
Note: If any of these items are missing or damaged, please contact the
manufacturer or a sales representative immediately.
3.2 Operating environment
Observe the following points so that the device functions
faultlessly and thus has a long service life.
• Place the device securely on an even surface. Push no
objects under the device.
• Position the device so that the power cord is not impaired.
• The ambient temperature must be 10–40 °C (50–104 °F).
• The relative humidity should be less than 80%; moisture
should not condense on the instrument.
• Leave at least a 15 cm clearance at the top and on all sides
for air circulation to avoid overheating of electrical parts.
WARNING
Electrical dangers and fire hazard.
Only use the supplied power cable.
Only qualified experts may perform the tasks described in this section
of the manual, while adhering to all locally valid safety regulations.
WARNING
Removable power cables must not be replaced with inadequately
dimensioned power cables.
NOTICE
Protect the instrument from extreme temperatures from heaters,
direct sunlight and other heat sources.
To Next Page
Loading...
