45
Standard programs
1. Press Data Log Setup in the "Instrument Setup" menu.
• With the setting Auto Store: On the device saves all
recorded measurement data automatically.
• With the setting Auto Store: Off the device saves no
measurement data. To save the currently displayed
reading, select Options > Save icon from the results
display; the currently displayed reading only is saved.
2. Specify the output format of data to be exported using Send
Data Format. Select xml or csv.
3. The Auto Send: On setting allows the instrument to print all
recorded measurement data automatically when a thermal
printer is connected. Auto Send: On must be activated in
the Printer Setup for the thermal printer to enable this feature
(refer to section 5.2.7.1). If a PC is connected, the recorded
measurement data is imported automatically into a table.
4. Press OK to confirm the entry.
The instrument then returns to "Instrument Setup".
Note: When the instrument memory (data log) is full, the oldest data is
automatically deleted allowing the new data to be stored.
5.3.1.2 Recall stored data from the data log
1. Press Recall Data in the Main Menu.
2. Press Data Log.
A listing of the stored data is displayed.
To Next Page
Loading...
