95
Expanded programs
4. Press Next and define the results display.
Enter the next calibration formula (C2 or Cn)
In addition to the keys described in Table 11, a further function is
now available: Select Conc..
5. If a previously defined formula, in this case C1, is to be taken
into account in the formula for C2, press Select Conc.
6. Enter the numbering for the equation (for example, 1 for C
1
).
7. Press OK to confirm the entry. C
n
can now be linked with a
mathematical operation.
Note: The C
n
concentrations that are to be calculated are numbered
in sequence: C
1
, C
2
, C
3
etc.
Note: Whenever a C
n
formula is defined, the Formula list is
automatically increased by C
n+1
.
8. Once the formula has been entered, define the unit,
designation, upper and lower limit and display of the formula
as done previously for C1.
9. Once all necessary formulae have been defined, press
Done.
6.1.2.4 Enter an amount during a measurement
If the application program used requires the amount of the
sample to be factored into the calculation during analysis,
proceed as follows:
1. The amount is selectable via the Abs/Variables list or can
alternatively be entered via the keypad.
2. From the data overview, select Formula and press Edit.
To Next Page
Loading...
