40
Standard programs
The connection parameters must be configured for data transfer
to a PC or connection to a network.
1. Press PC & Printer in "Instrument Setup".
2. Press Network > Setup.
3. Press On.
4. Press IP address.
An IP address is used to send data from a sender to a
pre-defined recipient.
• If the IP for the DR 6000 is automatically assigned in the
network, no further adjustment occurs. A hostname can
optionally be assigned.
• If the instrument address is fixed, the connection must be
configured.
5. Select Fix to configure the IP address.
6. Press IP address and enter the address.
To Next Page
Loading...
