(10) Do not use the unit in a strong electromagnetic field or it may cause incorrect
measurements.
7. After use:
(1) Turn the unit off the way specified.
(2) Do not pull the cable(s) too much while disconnecting or it may cause damage.
(3) Clean the unit, AC adaptor, cables and probes and place them in right place for
the next use.
8. Storage
(1) Follow the caution (2) to (6) of section #4 Device placement in the previous page.
(2) When using the unit next time, perform the maintenance to make sure it works
properly and safety.
9. Maintenance and inspection
(1) Do the periodical maintenance by following the procedures mentioned in "§ 4-1.
Performance Check by User".
(2) The maintenance must be done at least once a year.
10. Probes
(1) Clean the probe using damp cloth before use. Using alcohol or thinner may
damage the probe.
(2) The probe transducer tip is very thin and delicate. Please handle with great care
and use the probe cap when not in use.
(3) Optional sterilizable probe (reusable & disposable) can be sterilized in the manner
described in § 5-2. Sterilizable Doppler probes. However, only one time
sterilization is possible for disposable probe, and do not reuse it.
Except optional ACP probe, do not sterilize probes by steam autoclave.
11. Ultrasonic gel
(1) Do not apply ultrasonic gel to the probe body other than the tip of probe.
(2) Using other materials such as baby oil and cream may damage the probe.
(3) The ultrasonic gel enclosed is non-sterile and do not use it for surgeries.
(4) Incidence of allergy: Discontinue use of gel if any allergic reaction occurs.
12. Battery
(1) When battery is extremely low, the LCD display will not operate. Also there will be
no speaker sounds. Charge the battery.
(2) Battery life is 300 full charges. When full charging life is obviously short, contact
your dealer for replacing battery.
13. For transportation of the unit, it should be packed properly to protect against shock.
To Next Page
Loading...
