hager TKP100A - Add Netatmo Weather Station; Add Comfort Device

Page 18/45
installer_07-2017
You can choose between:
– Connected device
– Security device
– Comfort device (KNX radio actuators/receivers)
The list of compatible products is available under hager.com/coviva.
Add Netatmo weather station (Figure 15)
The weather station (indoor module) has been commissioned and has been registered in the
WLAN network of the customer. The customer has created a Netatmo account.
 In the context menu select Connected device.
The view for entering the access data of the Netatmo account opens.
 Enter E-mail address and password for the Netatmo account of the customer and nish via
Let‘s go .
The connection setup of the app via the smartbox to the Netatmo account is displayed in the
app. If the connection is successful,
Netatmo is displayed.
 Activate the line with the description and change the name for the weather station if re-
quired.
 Finish the operation with Save or switch to the main menu via Back.
The added device is displayed under my devices .
 Carry out the operation with each additional, compatible device until all Netatmo devices
have been added and uniquely named.
Groups
Details
Save
Back
Temperature
Humidity
CO2
Pressure
Sound meter
23,3°C
35%
881 ppm
57dB
1028 mBar
Measurements
Weather station
none
11 2 3 4 5 6 7 8 9
- / : ; ( )
. , ? ! ´
€ & @ “
0
#+=
Let's go
Add a device
space.?123
my.customer@email.com
Adding Netatmo weather station
Enter the user name and password
of your Netatmo account.
return
i
my devices
Off
Off
Off
Comfort device
Wall light living ro...
Ceiling light living
Standard lamp s...
Connected device
Security device
Cancel
What kind of device
would you like to add?
i
my devices
my groups
Off
Off
Off
20°C
Wall light living ro...
Ceiling light living
Standard lamp sofa
Weather station
Lighting first floor
First floor
Figure 15: Add Netatmo devices
Add Comfort device (Figure 16)
 Select Comfort device in the context menu.
 Switch the app to the conguration mode via Let‘s go.
The app requests that the device to be integrated must be made identiable.
 To do this, briey press the fct button on the KNX radio actuator.
The actuator has switched to the conguration mode. The connection setup is displayed in
the app. If the connection is successful, the order number of the device is displayed with an
appropriate symbol.
If there are difculties setting up the connection, a clock is displayed and the attempt is can-
celled with Adding process failed or Time out. Then check in the compatibility list whether
the device can be integrated into the smartbox.
 If necessary, activate the line with the order number and give the added actuator(channel) a
name for the application – e.g. ceiling light living.
hager.com
coviva smartbox