Finish the operation with Save or discard via .
The added device is displayed under my devices und its function can be tested directly.
Carry out the operation with each additional actuator(channel) within the KNX radio installa-
tion of the customer until all devices have been added and uniquely named.
Comfort device
Let's go
Adding KNX device
1. Press the 'Let’s go' button and
your coviva controller will wait for
compatible devices
2. Now you have to press the
device pairing button
Light garden shed_TRE2...
i
Off
Off
Off
my devices
my groups
my covigrams
my favorites
Detector hall
Heating kitchen...
Light garden shed...
... ...
Figure 16: Add Comfort device
Edit/remove device (Figure 17)/(Figure 18)
After adding the devices, they can be edited in the app or removed again at any time.
Press
i
in the top right corner of the main menu.
Hold the button down for longer if using Android devices.
All elements in the main menu are switched to edit mode.
Select the device to be edited via
i
in the device list.
Details about the device, such as the switching state or the groups in which it is integrated, are
displayed.
Then implement the following actions as required:
– Change the name of the device by pressing the name line and entering via the displayed
keypad.
– Add device of a Group by activating the checkbox.
– Remove device from a Group by deactivating the checkbox.
– Device Add to Favorites or Remove from Favorites.
– Switch to the delete mode via Remove Device. Then press Remove Device again and
press the fct button on the device to be removed.
To Next Page
Loading...