4 Project handover
To complete the project process, the project must be handed over to the customer (administra-
tor).
The project must be handed over to the administrator immediately.
The handover procedure enables an optimum transfer of the unrestricted access rights for the
project from the installer to the administrator without exchanging access data and passwords.
This avoids any kind of security risks/gaps.
Only the e-mail address of the administrator is required for the handover. The administrator
must have set up his myhager account with this e-mail address.
Hand over project (Figure 30)
The (mobile) end device and the smartbox are online.
In the main menu press
and start the handover of the project with Logout and Hando-
ver.
If the administrator has not been created as administrator at the start of the project (Figure 12),
a corresponding message appears at this point.
In this case:
Select Add user.
Enter the e-mail address of the administrator, under which his myHager account is set up.
To conrm this, enter the e-mail address a second time and nish with Save.
The view switches again to the main menu.
The e-mail address of the administrator must be different from that of the installer. This must
be taken into account for personal need.
Press
again in the main menu and select Logout and Project handover.
Then:
Complete the project via the Transmit data button.
The installer no longer has access to the completed project. Only the creation of a new pro-
ject or the logout is possible via
.
The administrator receives an e-mail containing information that Connected Home can now
be used and the access data (e-mail address). The customer can now log in to the coviva
app as administrator using the access data dened under myHager.
To Next Page
Loading...