Carry out a user reset
Keep RESET button (10) pressed for more than 20 seconds, until the RGB LED display (1)
is slowly ashing yellow.
Release RESET button (10) briey and press once again to conrm the selection of the
reset mode.
Rapid yellow ashing of the RCB LED display (1) conrms the successful reset.
1 x
> 20 s
Figure 32: User reset
Carry out rest to factory settings
The device is disconnected from the mains voltage.
Keep RESET button (10) pressed and switch on the smartbox by plugging into the (13) pow-
er supply.
The RGB LED display (1) rst ashes red approx. 5 times slowly, then ashes red rapidly.
Release the RESET button (10) and wait a few minutes until the RGB LED display (1) no
longer ashes.
The reset has been carried out successfully.
Figure 33: Reset to factory setting
RGB LED display
The smartbox has a display (1) for signalling errors that occur or for displaying the process of
operations (see Table 6).
signal Cause
Flashing red Critical warning, such as re or burglary
Permanent red light Hardware or software error
Flashing yellow Technical warning, such as low-battery status of a
device in the installation
Flashing blue Update, a software update is being installed
Table 6: RGB LED display (1)
To Next Page
Loading...