13
E. Password setting
1. Either , or will be displayed if you press the button when is displayed.
2. If you press the ( ) button, (Open), (Partial) and (Restricted) will be
switched alternately.
3. If you press the button after selecting, the display will return to . *1、2
*1 The display will move to the following selection screen if you select (Partial).
4. If you press the button at 3, you will be asked whether or not the password function is needed when
moving to the temperature setting mode.
5.
Either (without password) or (with password) will be displayed if you press the ( ) button.
6. If you press the button after selecting, you will be asked whether or not the password function is
needed when moving to the preset selection mode.
7.
Either (without password) or (with password) will be displayed if you press the ( ) button.
8. If you press the button after selecting, you will be asked whether or not the password function is
needed when moving to the offset mode.
9.
Either (without password) or (with password) will be displayed if you press the ( ) button.
10. If you press the button after selecting, you will be asked whether or not the password function is
needed when moving to the Air flow mode.
11.
Either (without password) or (with password) will be displayed if you press the ( ) button.
12. If you press the button after selecting, the display will move to password setting screen.
*2
If you select (Restricted), the display will move to the following password setting screen.
If you select (Partial), the display will move to the following the password setting screen after selecting *１.
11. The hundreds digits in the display will begin to flash. It indicates that you can enter the value.
Press the ( ) button to enter the letter you required.
12. The tens digits in the display will begin to flash if you press the button after entering.
Use the same procedure to enter the letters for tens and units digit.
13. The display will return to if you press the button after entering the units digit.
To Next Page
Loading...
