1
1. SAFETY
Read and comply with all safety items in this manual before operating the pump. Only fully trained
personnel may operate or maintain pump.
If EN 1028 is applicable to the user, the end user must maintain the equipment in an operational
condition, as per regulation 5 in the Provision and Use of Work Equipment Regulations 1998.
1.1. Safety Headings
DANGERS, WARNINGS, CAUTIONS, or NOTICES that immediately precede a step apply directly to that
step and all sub steps. DANGERS, WARNINGS, CAUTIONS, or NOTICES that precede an entire proce-
dure apply to the entire procedure. DANGERS, WARNINGS, CAUTIONS, and NOTICES consist of two
parts: a heading (that identifies possible result if disregarded) and a statement of the hazard (that
provides the minimum precautions). NOTES are used to highlight operating or maintenance proce-
dures, practices, conditions or statements that are not essential to protection of personnel or
equipment. NOTES may precede or follow the step or procedure, depending upon the information
and how it pertains to the procedure/step. The headings used and their definitions are.
INDICATES A HAZARDOUS SITUATION, WHICH IF NOT AVOIDED WILL RESULT IN SERIOUS
INJURY OR DEATH.
INDICATES A HAZARDOUS SITUATION, WHICH IF NOT AVOIDED COULD RESULT IN SERI-
OUS INJURY OR DEATH.
INDICATES A POTENTIALLY HAZARDOUS SITUATION, WHICH IF NOT AVOIDED MAY RE-
SULT IN MINOR OR MODERATE INJURY.
ADDRESSES PRACTICES NOT RELATED TO PERSONAL INJURY.
NOTE
Highlights an essential aspect of an operating or maintenance procedure, condition, or
statement and/or provides pertinent ancillary information.
1.2. Training
Pump Training is available through the Hale Training Academy and may be accessed via the Hale
Products Inc. website (www.haleproducts.com), Godiva √erified Training (godiva.co.uk), or through
your local dealer or vehicle manufacturer.
1.3. Safety Summary
The following warnings are used in this manual. A booster pump is not a complete machine and safe-
ty as well as performance is impacted by installation as well as use.
A PRESSURE HAZARD MAY EXIST EVEN WHEN THE PUMP IS NOT RUNNING. PRIOR TO
REMOVING HOSES, OR CAPS FROM PUMP CONNECTIONS, RELIEVE PRESSURE BY OPEN-
ING DRAINS. BLEEDER VALVES SHOULD ALSO BE USED WHEN CONNECTING TO AN IN-
TAKE FROM PRESSURIZED SOURCE.
To Next Page
Loading...
