Hama DIT2010 User Manual

9
4. Informations and notes before getting started
Note – Optimal reception
• This product is equipped with an antenna connection
which allows the use of an active or passive antenna.
The antenna is connected with a coaxial F-connector.
• A wire antenna that enables DAB, DAB+ and FM
reception is included in the delivery.
• For best reception, ensure that the antenna is fully
extended
• Try various different positions if necessary to get the
best reception.
Network connection/
Preparing the internet connection
You can integrate this radio into a local network and
even access home servers or other authorised resources.
To receive internet radio or access non-local media
(streaming, such as Spotify Connect), the network must be
connected to the internet.
Note
The LAN connection is less susceptible to faults than a
WLAN connection. That´s why it´s recommended to use
a wired connection between access point (AP) and radio
to ensure an undisturbed reception.
4.1 LAN connection (wired network)
• Connect a LAN cable of type RJ45 to a free socket on
your router, switch or access point.
• Connect the other end of the LAN cable to the RJ45 LAN
socket on the radio.
• Make sure that the router is on and that you have an
Internet or network connection.
• If you have questions about router conguration,
please consult the operating manual of the router for
troubleshooting.
• A detailed description of how to congure the LAN
connection is given in the Wired network connection
(LAN) section.
4.2 WLAN connection (wireless network)
• Ensure that the router is switched on, is functioning
correctly and that there is a connection to the internet.
• Activate the WLAN function of your router.
• Follow your router´s operating instructions as regards the
correct functioning of the WLAN connection.
• A detailed description of how to congure the
LAN connection is given in the Wireless network
connection (LAN) section.
5. Getting started
5.1 Remote control
• Open the battery compartment cover. It is located on the
rear of the remote control.
• Pull the closing tab back (if present) and lift the cover.
With other models of remote control, it suces to simply
push the casing in the direction indicated.
A: Closing tab B: Sliding cover
Insert the batteries provided, paying attention to match the
polarities correctly. The correct polarity is indicated by the
plus and minus symbols in the battery compartment.

Hama DIT2010 Specifications

General

Brand	Hama
Model	DIT2010
Category	Radio
Language	English