Hama DIT2010 - View Settings; Netremote PIN Setup; Smart Radio-App; Network Profile

33
15.2.5 View settings
Here you can nd all the most important information about
all network connections currently used or congured on
the radio, such as: MAC address, WLAN region, DHCP
active/disabled, SSID, IP address, subnet mask, gateway
address, DNS (primary and secondary), etc.
[menu]
System settings

Network

View settings
15.2.6 NetRemote PIN Setup / Smart Radio-App
The radio can be controlled using the application Hama
Smart Radio.
For this, you have to have installed the app on your
terminal device (for example smartphone or tablet PC)
and your device has to be in the same network as your
radio. The PIN saved in the radio is to increase security and
prevents other users from connecting with the radio.
If the app is started on your terminal device (for example
smartphone or tablet PC) and it tries to connect with the
radio, a window will appear on your device requiring you
to enter the PIN.
• You can nd and change the PIN as follows:
[menu]
System settings

Network

NetRemote PIN Setup
• The radio PIN is set to 1234 by default.
• Use [tuning] to make changes.
• Conrm your changes by choosing OK.
15.2.7 Network profile
The radio automatically saves all successfully connected
network proles. This means that re-establishing these
connections (for example, after the radio was disconnected
from the power supply) does not require you to re-enter the
network access information.
• To remove network proles individually, proceed as
follows:
[menu]
System settings

Network

Network prole
• Select a network prole and press [tuning] to delete it.
• Conrm the prompt querying if you want to delete the
prole with YES.
• A prole that is currently active, or that is in use, cannot
be deleted.
Note - Data security
• Before giving or selling the radio to someone else, we
recommend performing a Factory Reset.
• This will completely and permanently delete all
network information and connections stored on the
device.