Hamilton Microlab STAR - Page 68

Microlab
®
STAR User Manual
Page 68 of 225 610766/02
&RPPDQGVRQOLQH
- &RPPHQW: For any user-defined comments in a method
- $VVLJQPHQW: assign a variable
- $VVLJQPHQWZLWKFDOFXODWLRQ: perform calculations
&RPPDQGVRQOLQH
- /RRS: Loop commands between start and end of loop
- /RRSEUHDN: Terminates a loop
- ,IWKHQHOVH: Condition command
&RPPDQGVRQOLQH
- 6HTXHQFH: Get current position
- 6HTXHQFH: Set current position
- 6HTXHQFH: Get end position
&RPPDQGVRQOLQH
- 6HTXHQFH: Set end position
-6HTXHQFH: Adjust sequences
- 2SHQILOH: To open a file before file operation
&RPPDQGVRQOLQH
- 5HDGIURPILOH: Read data out of a file
-:ULWHWRILOH: Write data into a file
- 6HWSRVLWLRQ: Set the file-pointer to a specific position
&RPPDQGVRQOLQH
- &ORVHILOH: To close a file after file operation
- 7LPHU: start a timer
- 7LPHU: wait for a timer
&RPPDQGVRQOLQH
-7LPHU: read elapsed time from a started timer
- 7LPHU: restart a timer
- 8VHU,QSXW: display an input box at a particular point in the program
&RPPDQGVRQOLQH
8VHURXWSXW: display an output box at a particular point in the program.
- &RPPXQLFDWLRQ3RUW2SHQ: Opens a com port
- &RPPXQLFDWLRQ5HDG: Reads data from a com port
&RPPDQGVRQOLQH
- &RPPXQLFDWLRQ:ULWH: Writes data to a com port
- &RPPXQLFDWLRQ3RUW&ORVH: Closes a com port
- 6KHOO call external program