Hamilton Microlab STAR - Page 83

Microlab
®
STAR User Manual
610766/02 Page 83 of 225
The needle eject command
- places the needles into the next available wash module, and
- starts the wash process (on request).
For both commands channel patterns can be set manually. The error settings are again
similar to those of the SMART Step pipette.
An additional SMART Step is available to set the wash parameters; see the section on the
wash station.
 60$576WHSVIRU3LFNLQJXSDQG5HOHDVLQJ7LSV
Two further SMART steps allow you to pick up tips from a rack and then dispose of them in
the tip waste after use.
Here is the dialog for the “pick up tips” step:
The dialog asks you to specify a tip sequence. You also have the option of specifying a tip
counter.