Interval period time
The interval period time range is 0.1~25.5 seconds, size is 0.1 seconds, default time is 1seconds.
Same codes reading delay
To av oi d re ad sam e codes m any ti mes, ca n s et th e th e eng ine i n setti ng ti me to re ad the s am e codes onl y one tim e
under this mode. Same codes reading delay, means if the engine read the same code, will compare the last reading
time, when the interval period is longer than delay time, then can read the same code, otherwise, no output.
* Same code reading
without delay
To Next Page
Loading...
Need help?
General
