8.3 Auto-sensing Mode
After setting, no need to press the trigger, the engine start identify the brightness, when the situation changed,
engine will start to read once it is stable, when dated transmit, the engine need some time (can set) to identify the
brightness, if not, engine work as the situation before, under this mode, user can also press the trigger to start to
read, once loose the trigger, engine enter into the self- conduction mode again.
Single reading time
Under the continuous reading mode, it means the max time the engine read the code, if exceed this time, engine
enter into the interval period not reading, single reading time range is 0.1~25.5 seconds, step size is 0.1seconds,
when it is “0”, means no limit on reading time, default time is 0.5 seconds.
Interval period time
The interval period time range is 0.1~25.5 seconds, size is 0.1 seconds, default time is 1seconds.
To Next Page
Loading...
Need help?
General
