16
Bandsaw
N2-35
Model L Aeq LW (A) Lpc
N2-35 73,3 dB (A) 84,1 dB (A) 2,3 mW < 130 dB (A)
Note:
To keep the noise emission as low as possible, always use sharpened tools and operate the machine
at the correct speed.
Do not overload the machine! It is safer and performs better if operated within its power range.
Ear protection must always be worn; however, such protection cannot be considered a substitute for
properly sharpened tools.
All values in dB(A) and with a measurement uncertainty factor of 4 dB(A).
4.5 Noise emission
The given values are emission values and not safe work-
place values. Although there is a correlation between
emission and immission levels, it is not possible to state
whether increased safety measures are required.
Factors which can considerably influence the present
immission level at the workplace include the duration of
exposure, the character of the work area and other influ-
ences in the neighbouring area.
Acceptable workplace values may also vary from country
to country. However, this information should help the user
to better assess the hazards and risks.
Depending on the installation location and other
variables, the resulting noise emission can differ by up to
4 db (A) from the given values.
Specifications
To Next Page
Loading...
