Hammer N2-35 - Attaching Bandsaw Unit; Attaching Bandsaw to Frame

26
min. 4 mm
!
"
!
#
Bandsaw
N2-35
7.2.2 Attaching the band saw to the machine frame
Fig. 7-3: Assembly - Bandsaw
Warning! Heavy dead weights can easily cause an injury
To facilitate assembly, ensure the presence of a minimum of one additional people.
Assembly - Bandsaw:
1. Do not screw in the fastening screws completely. The
distance between the bottom edge of the screw head
and the machine base should be at least 4 mm.
2. Tighten the screws once the angularity is set. Move the
machine in the direction of the slots.
3. Screw in the socket head cap screw with the
hex key (can be reached via the bore).
!4 x Fixing screws
"Slot
#Bore
Note:
If the machine stand is not mounted on the machine frame, the machine must be placed on a stable and level
surface at least 390 mm high.
Setup and installation