Hammer N2-35 - Specific Cutting Techniques; Cutting Round Workpieces; Cutting Workpieces on Upright Edge; Cutting Narrow or Thin Workpieces

40
!
Bandsaw
N2-35
8.7.2 Cutting round workpieces in the transverse direction
8.7.3 Cutting workpieces on the upright edge
8.7.4 Longitudinal cut of narrow or thin workpieces with the longitudinal guide fence
Fig. 8-15: Cutting a circular workpiece
Fig. 8-16: Auxiliary fence
Fig. 8-17: Push stick
Use an appropriate device with the minimum measure-
ments as depicted in Fig. to avoid the workpiece twisting
during the cutting process.
Operation
Use an auxiliary fence with the minimum measurements
to guide the workpiece safely.
Use a push stick as depicted in Fig. to prevent your
hands from coming too close to the saw blade.
!Push stick