21
!
Bandsaw
N2-35
6.5 Transport
6.4 Storage
Keep items sealed in their packaging until they are
assembled/installed and be sure to observe the stacking and storage symbols on the outside of the packaging.
Store packed items only under the following conditions
• Do not store outdoors.
• Store in a dry and dust-free environment.
• Do not expose to aggressive substances.
• Protect from direct sunlight.
• Avoid subjecting the machine to shocks.
• Storage temperature: -10° to +50° C.
• Maximum humidity: 60 %.
• Avoid extreme temperature fluctuations (condensation
build-up).
• Apply a coat of oil to all bare machine parts (corrosi-
on protection).
• When storing for longer than 3 months, apply a
coat of oil to all bare machine parts (corrosion pro-
tection). Regularly check the general condition of all
parts and the packaging. If necessary, refresh or re-
apply the coat of
anti-corrosive agent.
• If the machine is to be stored in a damp environment,
it must be sealed in air-tight packaging and protected
against corrosion (desiccant).
6.5.1 Transport locking device
Fig. 6-1: Transport locking device
The machine is partly assembled when delivered on the
pallet
The machine can be transported with a crane, forklift,
pallet jack or rolling carriage.
Attention! Risk of material damage!
Transport the machine according to the enclosed transport and assembly instructions!
The machine must not be lifted by the work table, sliding table or base! Ropes, belts and chains
may only be fastened to the base of the machine.
Note:
The transportation width is well under 1000 mm. This makes it possible to transport the machine
through doorways.
Transport, packaging and storage
To Next Page
