Hammer N4400 - 7 Operation; 7.1 Safety instructions

Operation





• Before assembling and installing the machine, check
to make sure it is complete and in good condition.
• Ensure that there is sufficient space for working
around the machine.
• Keep the work area orderly and clean. Components
and tools that are not fixed or have been left lying
around may be the cause of accidents!
• Ensure that all safety devices have been properly
installed.
• Adjustments to the machine or tool replacement may
only be conducted once the machine has stopped.
• Only clamp authorised tools to the machine.
• Install the vacuum system according to the instructions
and test its function.
• Only process workpieces that can be safely placed
on the machine and guided.
• Carefully inspect workpieces for foreign matter (nails,
screws) which might impair processing.
• Support long work-pieces with additional surface
equipment (e.g. Table extensions, Roll supports).
• Ensure that each unit is rotating in the proper direc-
tion.
• Keep tools for handling short and narrow workpieces
close at hand.
• Before switching on the machine, always check to make
sure that there are no other persons in the immediate
vicinity of the machine.

• When changing to another workpiece or when there
is a malfunction, first switch off the machine and then
secure it against being switched on again accidentally.
• Do not switch off, circumvent or decommission pro-
tective and safety devices during operation.
• Do not overload the machine! It is safer and performs
better if operated within its power range.


• Persons with long hair who are not wearing a hairnet
are not permitted to work on or with the machine.
• It is prohibited to wear gloves while working on or
with the machine.
All jewellery (rings, bracelets, necklaces, etc.) must
be removed before starting work on or with the ma-
chine.


• Sturdy, tight-fitting clothing (tear-resistant, no wide
sleeves).
• Protective footwear that protects the feet from heavy
falling objects and prevents sliding on slippery floors.
• Ear protection to protect against loss of hearing.





19