Hammer N4400 - Index

Bandsaw
N4400
Index
Bandsaw
N4400


Adjusting the belt tension, 28
Angular cuts, 24
Applications, 25

Causes and problem elimination, 30
Changes, 8
Circuit diagram, 32
Circuit diagram 1 x 230V, 32
Circuit diagram 3 x 400V, 33
Circular cuts, 24
Cleaning, 27
Conversions, 8
Copyright, 6
Cross cut, 24
Cutting circular work-pieces, 23
Cutting work-pieces on the upright edge, 23

Dangers, 10
Data plate, 16
Declaration of Conformity, 11
Dimensions, 12
Disposal, 7
Drive belts, 28
Dust extraction, 14

Electrical connection, 12
Explanations of the symbols, 5

Faults, 29

General, 5

Installation, 17
Installation dimensions, 18

Liability, 6
Longitudinal cut along a line, 22
Longitudinal cut of narrow or thin work-pieces, 23
Lower blade guide, 26
Lubrication, 27

Maintenance, 27

Noise emissions, 13

Operation, 19
Other risks, 10
Overview, 15

Parallel cutting fence, 21
Personal protective equipment, 10
Positioning, 17

Safety, 8
Safety instructions, 17, 19, 27, 29
Saw blade maintenance, 25
Saw blade replacement, 22
Saw blade selection, 25
Setting the 90° end stop, 20
Setting the saw blade guides , 26
Setting up the machine, 15
Setting up the work table, 28
Spare parts, 6
Storage conditions, 12
Switching off the machine, 20
Switching on the machine, 20

Technical data, 12
Tension saw blade, 22

Upper blade guide, 26

Warranty, 6
Warranty notice, 6
Weight, 12
What is required of the personnel, 9
What to do after rectifying the fault, 29
What to do in case of a fault, 29
Working techniques, 20
Work safety, 9
40