The motor will not start Safety break switches are breaking
the electric circuit
The On-switch on the motor safety
switch will not engage
One of the emergency-stop buttons
is pressed down.
The machine is not performing Incorrect motor connection
Loose drive belts
The cuts are not straight
The saw blade is torn at the base of the
individual teeth
The saw blade is rupturing on the rear side
Poor welded joint
The rear support roller of the saw
blade guide is defective
The saw blade is slipping to the back at
the beginning of the cut
Ensure that the side doors are
closed properly
Ensure that the Emergency Off
Switch (if present) is unlocked
Check that the air brake switch
is in the correct position, or if a
Y-switch is present, check that it is
set to „0“
Contact an electrician
Contact an electrician
Incorrect sharpness and constant
overheating, or otherwise incor-
rect set of saw blade
Tension according to these instructions
Check sharpness and set of saw
blade
Check the guide fence alignment
Width of saw blade is too thick in
relation to the diameter of the wheel
Defect or soiled wheel running
surfaces
Contact a qualified technician
Feed rate or pressure is too high
during cutting
Remove present welded joint or
redo welded joint
The saw blade is not sharp
enough or is unsuitable for the
type of material to be cut, or the
surface of the wheel is defective
The blade is too thick in relation
to the diameter of the wheel
Incorrect blade tension
Faults
Incorrectly aligned wheels
To Next Page
Loading...
