Hammer N4400 - Cutting Round Work-Pieces in the Transverse Direction; Longitudinal Cut of Narrow or Thin Work-Pieces with the Guide Fence; Cutting Work-Pieces on the Upright Edge

Use an appropriate device with the minimum measure-
ments as depicted in Fig. 12 to avoid the work-piece twist-
ing during the cutting process.
Fig. 12: Cutting a circular work-piece
Use a push stick as depicted in Fig. 13 to prevent your
hands from coming too close to the saw blade.


Use an auxiliary fence with the minimum measurements
to guide the work-piece safely.
Fig. 14: Auxiliary fence

!Push stick
23
!