Fig. 9: Saw blade replacement
• Disconnect the machine from the mains supply.
• Remove table insert and positioning pin.
• Open wheel door.
• Unthread old blade through the machine table.
• Place new saw blade over both wheels (note the di-
rection of the cut!).
• Release the clamping lever and using the hand
wheel, set the saw blade track so that it lies in the
centre of both wheels (thereby turning the wheels!)
Close the clamping lever.
!Positioning pin
"Table insert
#Hand wheel
$Clamping lever
• Check the saw blade tension and if required, adjust
with the hand wheel. The values refer to the saw
blade width.
Fig. 10: Scale
!Scale
"Hand wheel
All uses which differ from the following work techniques
have not been intended for this machine and are therefore
not authorised.
Feed the work-piece with constant speed and pressure for-
wards without applying sideways pressure. Do not interrupt
the cut and do not pull the work-piece backwards. When
cutting large pieces, use appropriate table extensions or
roll supports.
Fig. 11: Longitudinal cut
!
"
$
#
!
"
To Next Page
Loading...
