99
In the handheld Undervoltage Cutback
.
LED status indicator light shows as follows
Red Yellow
first digit 2
Red Yellow
second digit 3
The numerical codes used by the yellow LED are listed in the troubleshooting chart (Table 6),
which also lists possible fault causes and describes the conditions that set and clear each fault.
Troubleshooting
This fault codes provide the following information:
Fault code
Display fault name on the Curtis programmer
Display caused by the fault
Probable fault reason
Fault deep reason
Troubleshooting
wiring error or truck malfunction, you can try to restart
through key switch. If fault still exists, please turn down key switch, check if the connector of pin
35 connects right or gets dirt, after repair and clean , reconnect, and then start again.
To Next Page
