31
4.4.2 Lithium battery charging
Model-type: SPC-24100
Input: AC186 260V/50-60Hz/20A
Output: DC29.2/100A
Safety precautions before charging:
Please choose to charge in a relatively safe environment (such as to avoid liquid, fire and
other environment).
The necessary extinguisher (yellow sand and powder fire extinguisher) should be equipped
around the charger so that emergency extinguishing can be carried out under extreme
conditions.
Before charging, confirm that there is no dust, water and other foreign objects in the charging
gun and charging socket. If there is any foreign matter, it should be cleaned before it can be
charged. Otherwise, the charging gun and charging stand may not be well-connected to
cause heat or even fire.
Do not modify or disassemble the charging port and charging equipment, which may result in
charging failure and fire.
After the charging is finished, do not disconnect the charging device when it is wet or standing
in the water, as this may cause electric shock and cause personal injury.
Provide adequate ventilation during charging. To avoid damage to charger cord plug and
receptacle, do not pull on charger cord plug. Do not twist, rock or bend plug sideways. Do not
use if plug or receptacle is damaged. Loose or feels hot otherwise fire, property damage or
personal injury may result.
Connect only properly grounded AC outlet. Do not touch uninsulated protion of output
connector or uninsulated battery terminal. Never try to change a frozen battery. There s the
danger of explosion! Maintenance and repair must only be carried out by a qualified specialist
who is familiar with the dangers involved and aware of relevance regulations.
CAUTION
When using for the first time, it is recommended that engineers and technicians with
lithium battery forklift electrician's and electrician's knowledge are advised to
participate or carry out the operation under the correct guidance of our company's
technicians. It is forbidden to disassemble the lithium battery forklift battery pack
without authorization. If there are any questions or uncertain questions, please
contact the company's technical department or after-sales service department.
To Next Page
Loading...
