35
Use thermometer to measure the
temperature for electrolyte.
Put the straw of densimeter into
electrolyte uprightly, extrude rubber
tube with hand and the electrolyte will
be sucked into the glasses tube and
then the floater of the densimeter will
float.
Numerate the reading of the
densimeter.
CAUTION
The dobber of densimeter must rise
uprightly without depending on the
glass pipe.
2 Measuring the proportion
Use gravimeter to calculate the electrolyte
proportion.
3 Conversion of the specific gravity
The specific gravity at the standard
temperature of 30
0
C should be converted as
follow:
D30= Dt + 0.0007( t - 30 )
Therein to D30 the specific gravity at
the standard temperature of 30
0
C
Dt the specific gravity at the
temperature of t0C.
t the temperature of the distilled
water during convert.
·The specific gravity referred in this book is
measured all at the temperature of 30 .
Charger
Storage battery of this truck equips with PCA
Automatic Charger Operation Instruction.
1 The charger is automatic high
frequency charger. The capacity voltage is
220V AC. The input current is not less than
15A. The output voltage is DC 36V.
Maximum charge current is 35A. The total
charge procedure is automatical. For more
information please refer to charger
manual.
2 Connection with earth wire for using.
3 Replacement fuse, first plug out the
plug.
4 Non-
hood to check or repair.
5 Do not rebuild or disassembly charger.
6 Prevent charger overheat in high
To Next Page
Loading...
