13
– Charger matching: The matching of charging parameters of the battery has a significant
impact on the performance and lifespan of the battery, so users should choose a
high-quality charger with the same charging parameters as the original charger when
replacing the charger.
– During the use of the battery, it is necessary to prevent situations such asover
discharge, over charging, or under charging, otherwise the battery will be damaged. If
possible, the battery should be charged in a timely manner, and it is strictly prohibited to
continue driving after the instrument shows that the battery is low; The normal discharge
depth should be 50%, generally not greater than 80%.
– When the stacker is not in use, the battery must be charged and stored. It is
recommended to charge it once a week when not in use.
– The battery capacity is based on the ambient temperature of 25 ℃, and it is normal for
the driving range to decrease as the temperature decreases. For every 1 ℃ decrease in
temperature, the battery capacity decreases by approximately 1%, and it is recommended
to avoid using it in environments below -10 ℃ as much as possible.
– The ambient temperature during charging should be controlled between 5 ℃ and 40 ℃,
and good ventilation should be maintained. Charging should be done at room temperature
in winter to ensure sufficient battery charge.
– The battery is a consumable, and after a period of charging and discharging cycles, its
capacity will gradually decrease, causing a gradual decrease in the range,whichisa
normal loss.
3 Charging the battery
3.1 Charging Cautions
– Park the truck securely (see Chapter E) and starting to charge with the build-in charger.
– Before starting charging, check the cable connections and plug connection components for
obvious damage.
– The space for charging stackers should be maintained with sufficient ventilation.
The process of stacker operation is the discharge process of the battery, and excessive
discharge of the battery is strictly prohibited. After the stacker is running, the battery should be
chargedinatimelymanner.
● This stacker has its own on-board charger. The charging power supply of the on-board
charger must be single-phase power frequency AC power supply. It is prohibited to use DC, AC
two-phase/three-phase and other non single-phase AC power supplies.
● Please power off when charging!
3.2 Power interface
– Input voltage: 85Vac~265Vac
– Input frequency: 47Hz~63Hz
– Input current: 1.5A/220Vac, 3.5A/110Vac
To Next Page
Loading...
