20
8
Emergency
reverse button
●
When the safety protection function is triggered by pressing this button,
the stacker immediately travels in the direction of the fork for about 3
seconds, and the parking brake is activated. The stacker can only be
started again when the driving switch is restored to its initial position.
9 Travel switch
●
Control the direction and speed of stacker travel.
10
Lifting/lowering
button
●
Lifting load items.
11 Horn button
●
When horn button is pressed, the horn will ring, as a warning.
12
Remote Control
Key
○
With Remote control device for lifting and lowering, maximum driving
speed setting, and horn function.
●= Standard ○=Optional ○= Different specifications available for selection
Charging status indicator[4]
Display the operating status of the built-in charger:
● Flashing red light: charging in progress.
● Green light always on: charging completed or waiting for battery.
● Yellow light always on light: battery malfunction.
● Flashing yellow light: charger malfunction.
Handle control
– The handle control box is used for
steering and braking control.
- When the handle control box is turned
left or right, the stacker can be steered
in the corresponding direction. The maximum
rotation angle of the handle control box is
about 175°.
–
When the handle control box is pushed
down to a horizontal position or pulled up
to a vertical position, the stacker can be
braked. These two positions are set by
the brake micro switch. The default state
is open circuit, and the working state is
closed circuit. The brake micro switch is
normally at the horizontal or vertical position
of the handle control box.
Handle control box
We patented multifunctional intelligent tiller
handle is unique design for quick fault
diagnosis, enabling an easier service, shorter
service time and lowered labor costs.
To Next Page
Loading...
