45
– Use a feeler gauge to check if the brake air gap "Z" meets the requirements.
– Adjust the three installation screws and hollow screws according to the diagram, adjust the
air gap "Z", and then tighten the brake installation screws.
In general working condition, the first air gap adjustment should proceed after brake working for
1500～2000hours, frequency of air gap adjustment is every 6 months. In severe working
condition, like frequently brake, repeatedly sudden brake, the first adjustment can be shortened
and adjust the interval.
1.6.5 Braking principle diagram
The forklift traveling motor is equipped with an electromagnetic brake. When the forklift stops,
the electromagnetic brake is released, and the brake pads firmly lock the motor shaft, leaving
the vehicle in a mechanical braking state.
To Next Page
Loading...
