27
Never carry passengers.
Emergency Stop
– Pull down the emergency disconnect switch(2), all electrical functions are deactivated.
Automatic braking
Automatic braking occurs when the tiller is released – the tiller automatically sets
itself to the upper brake zone (B1 & B2).
If the tiller moves slowly to the brake zone(F), the cause of this fault must be rectified.
Travelling
Travel with raised forks / raised load beyond 500 mm above the ground is prohibited.
Do not drive the stacker unless
the panels are closed and
properly locked.
– Start up the stacker (refer to
section 3).
The travel speed is governed
by the travel switch (9).
– Set the tiller (1) to the travel
range (F) and press the travel
switch (9) in the desired
direction (fwd. or rev.).
Steering
– Apply the tiller (1) to the left
or right.
Braking
The braking pattern of the stacker depends largely on the track conditions. The driver
must take this into account when operating the stacker.
Braking with the Service Brake:
– Set the tiller (1) up or down to one of the brake
zones (B1&B2).
The service brake is the generator brake. Only
when this brake fails to achieve the necessary
brake force is the mechanical brake applied.
To Next Page
Loading...
