28
Plugging:
– You can set the travel switch (9) to the opposite direction when traveling.
– The stacker braked regeneratively until it starts to move in the opposite direction.
Braking with the Coasting Brake:
If the travel switch is set to 0, the stacker automatically brakes regeneratively.
In hazardous situations set the tiller to the brake position.
Driving on inclines
Loads must always be carried on the end of the stacker facing uphill.
Preventing the stacker from “rolling downhill”:
– With the travel switch set to zero, the brake is automatically applied after a short jerk
(the controller detects the stacker is rolling back on the slope). The service brake is
releasedagainviathetravelswitch,whichisalsousedtoselectthespeedand the
travel direction.
Before lifting a load, the driver must ensure that it is correctly palletised and that the
capacity of the stacker is not exceeded.
– Drive the stacker with forks as far as possible underneath the load.
Lifting/lowering
– Both lifting and lowering adopt stepless speed regulation function, the lifting/lowering
speed can be infinitely controlled
– Push backward or forward the lifting/lowering button switch until the required lifting
height has been reached.
To Next Page
Loading...
