43
1.6.2 Brake installment
– Place the flat key (13) into the keyway on the motor shaft (9),
press the shaft sleeve (4) onto the shaft (9), and secure it with
an internal circlip (14).
– Install the friction disc (5) onto the motor end face using
three friction disc mounting screws (12).
– Place the friction brake pad (3) on the shaft sleeve.
– Install the stator assembly (2) onto the friction disc (5) using
three brake mounting screws (1).
Before installation, remove the three transport fixing rubber pads
from the stator assembly.
– Tighten the three brake mounting screws (1) with a torque
wrench (15) and check the brake air gap "Z" with a feeler gauge
(16).
– Put on the dust cover (6).
– Connect brake wiring.
● Nodamageontheouterofwiretoavoidcircuitdamage.
● Never process the locating face and hold of the product to
avoid magnetic return path.
● Mount on the motor shaft lightly, no damage the friction
surface, get rid of burr from mounting hold and face, install shaft
sleeve on the shaft, and fix with snap spring.
● Measure brake connected DC voltage and compare it with
the voltage given on the nameplate. Deviation within 10% is
allowable.
● During brake install and use, do not stain oil.
To Next Page
Loading...
