25
11) Steering system
Left or right turn the handle to make the stacker run around 3 turns, and then check if the
steering system is normal.
12) Check chain tensity
– Lift forks up 10～15cm.
– Press the middle of the chain and see if
the left & right tensity is the same.
–Tensityadjustment：screw off the nut①,
adjust nut ② to keep the same tensity of the
two chains, and then tighten the nut ①.
13) Horn
Press the horn button to check sound.
14) Appearance
Check the stacker appearance for clean, rust or paint spalling.
15) Others
Check whether there is any abnormal noise, whether wiring is regular or fastener loosens etc.
Before the stacker can be commissioned, operated or a load unit lifted, the driver must
ensure that there is nobody within the hazardous area.
Checks and operations to be performed before starting daily work
–
Perform a pre-operation inspection to ensure that all functions and conditions are normal.
Switching on the stacker
– Pull up the emergency
disconnect switch(2).
– Turn on the key switch(4). The
handle monitor displays the
battery level status.
Then, the stacker is in a ready
operation state.
To Next Page
Loading...
